Plu Programmed Data Copying - TEC MA-1450-1 Series Owner's Manual

6. PROGRAMMING OPERATIONS
6.9

PLU PROGRAMMED DATA COPYING

This operation is used to copy the programmed data of a PLU item and to use it in programming another PLU
item, thus eliminating time in PLU programming operation.
CONDITION To program new PLUs or to change any programmed contents of PLUs:
To change the PLU of the copy-destination with sales data not zero:
OPERATION Mode Lock: SET
4 [@/FOR]
ex.) To program PLU 90701 (7-up Small-B) again that
was once programmed and then deleted, by
copying the programmed data of PLU 90601 (Coke
Small-B):
Mode Lock: SET, enter 4, depress [@/FOR]
90701 [PLU] (PLU Code of the copy-destination)
[NS]
90601 [PLU] (PLU Code of the copy-source)
2 [ST] 307 [#] 213 [#] 705 [#] 700 [#] [#]
503 [#] 613 [#] 601 [#] 612 [#] 612 [#]
213 [#] 402 [#] [ST]
(Address 2, Name changed into: 7-up Small-B)
9 [ST] 7 [#]
(Address 9 , PLU Group No. changed into: 7 )
[AT/TL] (to end this submode)
Any time outside a sale (except the following case)
After PLU Reset
|PLU Code of the copy-destination| [PLU]
|PLU Code of the copy-source| [PLU]
The programmed data of the copy-source PLU is now copied to the copy-destination
PLU (except the PLU Code). Then follow the procedure on the page of Programming
or Changing to change data of any required Addresses.
TEC
1343 PEACH DRIVE
PHONE : 87-6437
Open
Closed: every Wednesday
12-19-1994
090701
Coke Small-B
#00 090601
#02
#09
00030
6-22
6.9 PLU PROGRAMMED DATA COPYING
[NS]
STORE
8:00am to 7:00pm
MON #3001
P04
7-up Small-B
07
0030
EO1-11095