TEC MA-1450-1 Series Owner's Manual page 114

6. PROGRAMMING OPERATIONS
2. Even if the option "Store Name Print by RUBBER STAMP" is selected, data can be programmed
for the store name/message. However, the Rubber Stamp, instead of the programmed name/
message will actually be printed for operations to issue receipts.
If the option "Store Name Print by DOT PRINTER" is selected, use 1 through 4 for the store
name/message and 5 through 7 for the commercial message data, as Line No.
The range of Line Nos. 5 to 7 is unavailable to a manual-cut printer.
3. If no commercial message is required on the receipt, program blanks for all three lines. As a
result no extra lines will be fed. If any one of the three lines is programmed, the two other lines
will cause line feeds.
4. The 4-line range assigned for the store name/message will be either printed or fed, regardless of
any system option selection.
5. If any incorrect characters have been programmed, depress the [C] key to clear all the
characters on a line and then re-enter characters from the beginning, or end the line with an [ST]
and re-program the entire line. The new data will be active.
6. When all the lines have been programmed, do a check by issuing a receipt. Only the lines with
errors need to be re-programmed; other lines will not be affected.
ex.) To program the following draft as the Store Name/Message and Commercial Message (under the option
"Store Name by DOT PRINTER"):
T
T T T T 1 3 4 3
T T T T T
T T T T T T T T T T T T T T T T T T T T T T T T
O p e n T T
C l o s e d :
T T T T T T T T T T T T T T T T T T T T T T T T
6.6 STORE NAME/MESSAGE AND COMMERCIAL MESSAGE PROGRAMMING (Submode 1)
E C S T
T P E A C H
P H O N E : T 8 7 - 6 4 3 7
8 : 0 0 a m T t o
T e v e r y T
O R E
T D R I V E
T 7 : 0 0 p m
W e d n e s d a y
6-9
Line No. 1
Store Name/Message
portion, which can
Line No. 2
be replaced by a
RUBBER STAMP print
under the option
Line No. 3
"Store Name by
RUBBER STAMP".
Line No. 4
Line No. 5
Commercial
Line No. 6
Message portion.
Line No. 7
EO1-11095