Mitsubishi Electric MXZ-2D33VA Service Manual page 170

OPERATING PROCEDURE
2. Removing the outdoor control P.C. board the out-
door power P.C. board and the noise filter P.C.
board
(1) Remove the service panel.
(2) Remove the top panel, the front panel, and the rear
panel.
(3) Disconnect all connectors and lead wires on the outdoor
control P.C. board.
(4) Remove the outdoor control P.C. board.
(5) Remove the screws fixing the outdoor power P.C. board.
(6) Disconnect all connectors and lead wires on the outdoor
power P.C. board.
(7) Remove the outdoor power P.C. board.
(8) Disconnect all connectors and lead wires on the noise
filter P.C. board.
(9) Remove the noise filter P.C. board.
3. Removing the reactor
(1) Remove the top panel (Photo 1).
(2) Disconnect the reactor lead wire.
(3) Remove the screws of the reactor, and remove the reac-
tor.
4. Removing the fan motor
(1) Remove the service panel, the top panel, and the front
panel (Photo 1).
(2) Disconnect the connector CN931 and CN932 on the out-
door control P.C. board.
(3) Remove the propeller fan.
(4) Remove the fan motor.
OBH626K
Photo 4
Screws
of the
electrical
parts
Photo 5
Screws of the outdoor fan motor
Photo 6
Propeller fan
Propeller fan nut
Separator
170
PHOTOS
Screws of the reactor
Sound
proof felt