Gear Shifting - Mercury 200 OptiMax DTS Manual

NOTE:
Turn the ignition key switch to the "ON" position for approximately one minute. This operates the fuel
lift pump. Turn the ignition key switch back to the "OFF" position and then return the ignition key switch
to the "ON" position again for an additional minute. Turn the ignition key switch back to the "OFF"
position. The filling of the fuel system is complete.
5. For initial start of a new engine or for an engine that ran out of fuel or was drained of fuel, the fuel
system should be filled as follows:
a. Squeeze the fuel line primer blub until it feels firm.
b. Turn the ignition key switch to the "ON" position for three seconds. This operates the electric
fuel pump.
c. Turn the ignition key switch back to the "OFF" position, and squeeze the primer blub again
until it feels firm. Turn the ignition key switch to the "ON" position again for three seconds.
Continue this procedure until the fuel line primer blub stays firm.
6. Ignition key starting - Turn the ignition key to "START" position and release the key. The electronic
starting system will automatically crank the engine for starting. If the engine fails to start, the
engine will stop cranking. Turn the key to "START" position again until engine starts.
7. After engine starts, check for a steady stream of water flowing out of the water pump indicator
hole.
IMPORTANT: If no water is coming out of the water pump indicator hole, stop engine and check the
cooling water intake for obstruction. No obstruction may indicate a water pump failure or blockage in
the cooling system. These conditions will cause the engine to overheat. Have the outboard checked by
your dealer. Operating the engine while overheated will cause engine damage.

Gear Shifting

DTS PANEL MOUNT REMOTE CONTROL
IMPORTANT: Never shift outboard into gear unless engine speed is at idle. Do not shift outboard into
forward or reverse when the engine is not running.
OPERATION
3485
19805
58