Mercury 200 OptiMax DTS Manual page 73

Fuel Filter Removal/Installation Tool
Installation
1. Lubricate the O-ring seals with oil.
a
b
a - Filter
2. Install the fuel filter and tighten securely.
IMPORTANT: Visually inspect for fuel leakage from the filter while squeezing the primer bulb until firm,
forcing fuel into the filter.
DRAINING WATER FROM THE FUEL FILTER CHAMBER
NOTE: If a sufficient amount of water has accumulated in the fuel filter chamber, the warning system will
turn on. Draining the water from the fuel filter chamber is required.
1. Pull the drain hose off the right side fitting. Hold the open end of the hose over a container.
2. Use a 1/8 in. hex wrench and loosen the drain screw and drain the fuel filter chamber.
MAINTENANCE
Aids in the removal and installation of the fuel filter
cap assembly.
24896
65
91-896661
b - O-ring seals
3388