Advertisement
Network Settings Connected through a Router
1.
Gather the following from the ISP: Static IP address, Subnet mask,
Gateway IP.
2.
Plug in the network cable into the network port in the EDR1600.
3.
Enter the menu screen by pressing the config button.
4.
Then enter the system menu and go to IP Configuration Table.
5.
Enter the IP Address specifically assigned for the EDR1600 on your
network. (NOTE: IP Address is assigned by router)
6.
Enter the Subnet Mask Address assigned to your network.
7.
Enter the Gateway Address assigned to your network.
8.
Exit the Menu by clicking ok and Reboot the EDR1600 by powering
it down and back up.
(NOTE: Please be sure that ports 80, 1111,and 1600 are open. To open
any of the following ports please enter the port-forwarding portion of your
router and open these ports within that page.)
Quick Reference
6
Advertisement
