Aligning The Outside Lock; Testing The Operation Of The Outside Lock - Kaba SIMPLEX EE1000 Series Installation Instructions Manual

Hide thumbs Also See for SIMPLEX EE1000 Series:
Table of Contents

Advertisement

Aligning the outside
7
lock
1. Place the outside lock unit on the door so
the screw studs (A) pass through
the two
" (13 mm) holes (see figure
1
2
7-1, 7-2).
2. Align the latch tailpiece (A) with the shoe
retractor (B) of the cylindrical drive unit
(D) by depressing the latch bolt slightly.
Make sure that the latch prongs (C) and
cylindrical drive unit (D) engage each
other as shown in figure 7-3.
Testing the operation of
8
the outside lock
1. Turn the outside knob clockwise to the
stop position then release it.
2. Enter
the
factory-set
Depress buttons 2 and 4 at the same
time (release), then depress button 3
(release). You should feel a "click" as
each button is depressed.
3. Turn the outside knob clockwise to the
stop position and hold. Make sure the
latch is fully retracted, flush with the doors
edge.
4. Release the knob. The latch should
return to the fully extended position.
Alineación de la cerradura
exterior
1. Coloque la cerradura exterior en la puer-
2. Alinee la cola del pestillo (A) con el
Prueba de la cerradura
exterior
1. Gire el pomo exterior hacia la derecha
combination:
2. Ponga la combinación que viene de
3. Gire el pomo exterior hacia la derecha
4. Suelte el pomo. El pestillo debe salir
16
ta, de forma que las terminales de los
tornillos largos (B) y los espárragos (A)
atraviesen los 2 agujeros de
(véase las ilustraciones 7-1, 7-2).
dispositivo retráctil (B) de la unidad
cilíndrica de transmisión (D), ejerciendo
una presión ligera en el pestillo.
Asegúrese de que los dientes del pestillo
(C) y la unidad cilíndrica de transmisión
(D) se enganchan como lo muestra la
ilustración 7-3.
hasta el tope y luego suéltelo.
fábrica: oprima los botones 2 y 4 al
mismo tiempo (suelte); luego oprima el
botón 3 (suelte). Con cada uno de los
botones que apriete, deberá oír un
chasquido.
hasta el tope y manténgalo en esa
posición. Asegúrese de que el pestillo se
repliega totalmente, al ras con el borde
de la puerta.
completamente.
" (13 mm)
1
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents