Team Losi XXX-T Matt Francis Edition Owner's Manual page 15

Figure 25
41
!
Step 24. Place the right rear hub (65) between the outer rails
of the right rear suspension arm (50). Be sure that the ball stud
(10) is towards the front. Position a rear hub spacer (70) between
the hub (65) and the suspension arm (50) on each side of the hub
(65).
!
Step 25. Insert an outer rear hinge pin (71) into the suspen-
sion arm (50), through each of the two spacers (70) and rear hub
(65). Secure the hinge pin (71) with two 1/8" E-clips (41).
!
Step 26. Repeat Steps 24 and 25 for the left rear hub (66)
and left rear suspension arm (50).
Figure 26
!
Step 27. Thread a red plastic rod end (45) onto each end of a
2-1/2" turnbuckle (72). Tighten both rod ends (45) equally until the
rod is the same length as the one shown in Figure 26A. Make two of
!
these rear camber link assemblies.
There is a small tube of white grease in Bag B. It is
recommended that this be applied to the threads of the turnbuckles
before trying to thread the plastic rod ends on.
*NOTE: Each end of the turnbuckle is threaded opposite. One
end has left-hand threads, the other right-hand threads. This allows
the length of the rods, once installed, to be adjusted without remov-
ing them.
Figure 27
!
Step 28. Attach one end of a rear camber link assembly from
Step 27 to the ball stud (10) in the right rear hub (65) and the
!
other end to the ball stud (26) in the rear shock tower (55).
Remember to attach the turnbuckles so that the threads
are in the same direction on all of your linkages.
!
Step 29. Repeat Step 28 for the left side of the truck.
BAG C (Continued)
71
45
65
72
Figure 27
1 1
10
70
41
45
72
Figure 26A
Figure 26
55
50
71
Figure 25
10
65