Team Losi XXX-T Matt Francis Edition Owner's Manual page 11

Figure 16
45
!
Step 25. Thread a red plastic rod end (45) onto each end of a
2-1/4" turnbuckle (46). Tighten both rod ends (45) equally until the
rod is the same length as the rod in Figure 16A. Make two of these tie-
!
rod assemblies.
There is a small tube of white grease in Bag B. It is
recommended that this be applied to the threads of the turnbuckles
before trying to thread the plastic rod ends on.
*NOTE: Each end of the turnbuckle is threaded opposite. One
end has left-hand threads, the other right-hand threads. This allows
the length of the rods, once installed, to be adjusted without remov-
ing them.
Figure 17
!
Step 26. Snap one end of a completed tie rod assembly to the
ball stud (11) in the steering idler arm (8). Snap the other end to the
ball stud (10) in the right spindle (29). Attach the other tie rod
assembly to the ball studs in the servo saver assembly and the left
!
spindle (28).
Once again, assure that all turnbuckles are mounted
with the threads in the same direction for easier adjustment later.
BAG B (Continued)
46
45
8
7
46
Figure 16
Figure 16A
45
Figure 17
29
10