Team Losi XXX-T Matt Francis Edition Owner's Manual page 14

Figure 24
22
27
!
Step 17. Thread a bluish short neck ball stud (22) into the inner
hole in the right rear hub (65), from the front (the side without the
recessed area) as shown in Figure 24.
IMPORTANT NOTE: Do not overtighten the ball studs.
!
Step 18. Place a "foam thing" (47) over the ball stud (22).
!
Step 19. Press a 3/16" x 3/8" sealed bearing (27) into the inside of
the right rear hub (65). Slide a rear axle (62) through the bearing (27) in
the rear hub (65).
*NOTE: If the 3/16" x 3/8" bearing only has one Teflon
(colored, woven-looking) in it, position the seal to the outside of
the hub.
!
Step 20. Slide an inner rear axle spacer (67) over the rear axle
(62) from the outside against the inside of the bearing (27). Place a
second 3/16" x 3/8" bearing (27) over the rear axle (62) and press
the bearing (27) into the outside of the rear hub (65).
*NOTE: If the 3/16" x 3/8" bearing only has one Teflon
(colored, woven-looking) in it, position the seal to the outside of
the hub.
!
Step 21. Place an outer rear axle spacer (68) over the rear axle (62),
against the outside bearing (27). The small side of the spacer (68)
should be positioned next to the bearing (27).
!
Step 22. Secure the rear axle (62) and the spacer (68) by inserting
a 1/16" x 7/16" spirol pin (69) through the small hole in the rear axle
(62). The pin (69) should be centered in the rear axle (62).
!
Step 23. Repeat Steps 17-22 for the left rear hub (66).
BAG C (Continued)
67 68
69
67
™ seal
27
™
seal
68
1 0
62
22
47
27
65
Figure 24
69