Presser Foot-To-Needle Plate Clearance On The Pfaff 5625-657/02 - Pfaff 5625-657/01 Instruction Manual

11 Presser foot-to-needle plate clearance
.04.22
Requirement
When presser foot 7 is raised
1. the hand lever 4 should be parallel to the needle thread tension unit 5,
2. the tip of crank 8 and bar 9 should be aligned and
3. there should be a clearance of approx. 11 mm between presser foot 7 7 7 7 7 and the needle plate.
8
Fig. 11 - 22
Loosen screws 1, 2 and 3.
Turn the hand lever 4 in accordance with requirement 1.
In this position, move stop 6 to touch the case and tighten screws 2.
Raise presser foot 7 with the hand lever.
Turn crank 8 and bar 9 in accordance with requirement 2 and tighten screws 3.
Turn linkage rod 10 (nuts 11) in accordance with requirement 3.
Adjust the needle thread tension release unit (Chapter 11.04.23).
7
11 mm
62-013
4
5
on the PFAFF 5625-657/02
11
9
1
Adjustment
10
6
3
2
11 - 23