Presser Foot To Needle Plate Clearance - Pfaff 2438 plusline Instruction Manual

13

Presser foot to needle plate clearance

.05.24
Requirement
When the hand lever is raised, the needle should penetrate exactly in the "needle hole
centre" of the presser foot and the presser foot to needle plate clearance should be 7 mm.
3
Fig. 13 - 25
Set the zigzag stitch adjustment lever at "0" and the stitch position adjustment lever at
"centre".
Let the presser foot drop onto the needle plate and reduce the pressure on the presser bar
by turning screws 1.
Place the feed dog adjustment gauge under the presser foot with the recess at the bottom.
Loosen screw 2 and raise hand lever 3.
Allow the needle to penetrate the needle hole and align the presser foot in accordance with
the requirement.
Press the presser bar lifting piece down and tighten screw 2.
2
Adjustment
-
+
1
81-038
13 - 26