Assembly Overview - Front Bumper Cover - Volkswagen Jetta 2011 Workshop Manual

Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
General body repairs, exterior - Edition 08.2012
– Apply adhesive as shown in illustration and tighten knurled nut
-2-.
– Remove all centring pins after minimum curing period, mini‐
mum curing period ⇒ page 174
1.3.4 Minimum curing period
Do not carry out any further work on bumper cover or brackets
until the minimum curing period of 30 minutes has expired.
In this time, the bumper cover must remain where it is and should
not be moved.
1.4

Assembly overview - front bumper cover

Note
There may be minor differences between bumper covers, depending on vehicle model.
1 - Front bumper cover
❑ Material PP/EPDM.
❑ Removing and installing
⇒ page 175
2 - Bolt
❑ Left and right.
❑ Points upwards.
❑ Specified torque: 2 Nm
3 - Bolt
❑ Qty. 4 on each side.
❑ Specified torque: 2 Nm
❑ Bolted to wheel housing
liner.
4 - Bolt
❑ Qty. 2 on each side.
❑ Specified torque: 2 Nm
❑ Bolted to wheel housing
liner.
5 - Bolt
❑ Qty. 4.
❑ Specified torque: 2 Nm
❑ Bolted to lock carrier.
174
Rep. gr.63 - Bumpers