T&C TC36.NG03.C. Instruction Manual page 3

2) Attach the manifold bracket to the fl oor shield in the bottom
of the fi rebox with one screw. (Fig. # 2)
3) Attach the manifold and pilot supply tubes to the bulk head
fi tting and tighten. (Fig. # 3) Ensure that all connections
are gas tight.
4) Attach spark electrode (ORANGE) and sensor leads to
the electrical bulk head. ( Fig. # 4) (The spark electrode
connection has a red dot above it)
NOTE: If converting to propane refer to the propane
conversion section before continuing. Pg. 9
TC36.NG03.C 010408-16
Fig. # 2
Fig. # 3
Fig. # 4
3