Table of Contents
Advertisement
12) Fill in the date and the name of the person who performed the
conversion in the white area on the conversion label. Peel off
the protective backing and apply the conversion label directly
over the gas specifi cations on the rating label.
13) Attach the access panel to the side of the fi rebox with the
previously removed screws. (Fig. #26)
Note: Gasket must be installed with access panel.
Gas Pressure Test
Note: To test the gas pressure, turn off the gas supply before
removing the blanking plug from the supply pressure test
port or manifold pressure test port.
Verify gas pressures with the fi replace lit and on the
highest setting.
1) Remove the plug from the pressure test port. The plug is
located between the right side lintel and fi rebox side. (Fig.
# 27)
2) Thread the extension test fi tting into the open test port.
(Fig. # 28)
3) Attach a pressure gauge onto the fi tting
4) When testing is complete remove the extension piece and
replace the pipe plug. Thread sealant will be required to
ensure a gas tight connection.
CORRECT GAS PRESSURE REQUIREMENT:
Supply Pressure
(For purpose of input adjustment)
Minimum
Maximum
Manifold Pressure
Maximum
Minimum
TC36.NG03.C 010408-16
Natural Gas
Propane
5.0" wc
12.5" wc
13.9" wc
13.9" wc
3.8" wc
11.0" wc
2.1" wc
5.5" wc
Fig. # 26
Fig. # 27
Fig. # 28
11
SUPPLY
SUPPLY
MANIFOLD
MANIFOLD
Advertisement
Table of Contents
