T&C TC36.NG03.C. Instruction Manual page 10

6) Slide the pilot adjustment band over and ensure that the
hole in the orifi ce band is showing. (Fig. #20 indicates NG
position, Fig. #21 indicates LP position)
Fig. # 20
Fig. # 21
7) Remove access panel, 10 screws, and set aside
8) Remove the minimum rate screw located in the valve.
(Fig. #22)
Fig. # 22
Removing the Minimum Rate Screw
The minimum rate screw is sealed with an o-ring near the
bottom of the screw. Use a thin bladed screwdriver to back the
screw out to the limit of the threading. At this point, a groove
on the screw body will be visible just above the valve body.
Insert a thin tool (knife blade or fi ne screwdriver blade) into
the groove and gently pry the screw up.
MINIMUM RATE MINIMUM RATE
SCREW SCREW
9) Replace the minimum rate screw with the one provided
in the propane conversion kit supplied with this fi replace.
Ensure that the screw is fully installed. (Fig. #23)
Fig. # 23
10) Pull off the rubber cap from the top of the pressure
regulator. (Fig. #24)
Fig. # 24
11) Press down on the center post and rotate 90°. The center
post should stay down. (Fig. #25). Replace the rubber
cap.
Fig. # 25
10
MINIMUM RATE MINIMUM RATE
SCREW SCREW
TC36.NG03.C 010408-16