Housing and Camera Setup
STEP 1 - Attach Tray and Handle to the Housing
Skip STEP 1 if Tray is factory installed.
Using a 9/16" open/box end or socket Wrench (not supplied), firmly
tighten the External Tray and Spacer to the Housing Base using the two
3/8-16 Nuts and Washers supplied in the accessory package. One side
of the Spacer has an adhesive backing. Remove the Protective Film to
adhere the Spacer to the Tray.
Note: Tray and Handle may be attached before or after the camera is
secured in the Housing. We recommend attaching it immediately to avoid
scratching table tops with the Tray Mounting Bolts.
Tray Mounting Bolt
Spacer
Protective Film
Washer
MADE IN USA
3/8-16 Nut
External Tray
& Handle
Wrench - not supplied
7