Housing And Camera Setup Steps; Step 1 - Attach/Remove Tray And Handle - Ikelite 6973.03 Instruction Manual

HOUSING and CAMERA SETUP STEPS

STEP 1 - Attach/Remove Tray and Handle

Skip STEP 1 if Tray and Spacer are factory installed.
One side of the Spacer has an adhesive backing. Remove the Protective
Film to adhere the Spacer to the Tray.
Using a 9/16" open/box end or socket Wrench (not supplied), firmly
tighten the External Tray and Spacer to the Mounting Bolts using the two
3/8-16 Nuts and Washers supplied in the accessory package. Reverse
procedure to remove. Note: Tray and Handle may be attached before or
after the camera is secured in the Housing. We recommend attaching
them immediately to avoid scratching table tops with the Mounting Bolts.
Tray Mounting Bolt
Spacer
Protective Film
Washer
Adhere Spacer to Tray
before attachment to
Housing.
MADE IN USA
3/8-16 Nut
External Tray
& Handle
9/16" Wrench - not supplied
7