Strobe Use And Compatibility; Strobe Compatibility; Ikelite Housing Conversion Circuitry - Ikelite 6950.52 Instruction Manual

Strobe Use and Compatibility

Strobe Compatibility

- AF35 ........................no
- DS50........................yes, above serial number 70000
- DS51........................yes
- DS125......................yes, above serial number 5000
- DS160, DS161 ........yes
- DS200......................yes, above serial number 7163
- Non-Ikelite ..............yes, manual flash exposure only

Ikelite Housing Conversion Circuitry

This small compact housing has Ikelite designed and patented
Conversion Circuitry built right in. The Conversion Circuitry provides real
TTL flash exposure when used with Ikelite DS series strobes. The
Circuitry is automatically activated once a DS series strobe is attached
to the housing and turned on. Once attached, turn the strobe on first
before turning on the camera. The circuitry cannot be powered up or
used by non-Ikelite strobes.
Attaching a Sync Cord to the Housing -
The Housing Bulkhead is designed to accept sync cords with Ikelite 5
pin connector fittings.
1. Lightly lubricate the Sync Cord O-ring. Use ONLY Ikelite lubricant
(supplied with housing). Other lubricants may cause the o-ring to swell
and seal improperly.
2. Remove Bulkhead Cap from Housing Bulkhead.
Diagram E, Page 16
15