Tone Setting; Stereo/Mono Setting - Geemarc CL7400 User Manual

SETTINGS

Tone Setting

The Tone can be controlled by pressing the tone button on the headphones. Press
and hold this for 2 seconds. At this point, pushing headset '+' button will increase the
high tones. Pushing the '-' button will increase the low tones. At minimum, maximum
or middle point a beep will be heard. Tone setting mode will switch off automatically
after 5 seconds.
Min
11111
Mid
'
Max
13
SETTINGS

Stereo/Mono Setting

Stereo or Mono mode can be controlled by moving S/M switch to the
desired side. This switch is found on the underside of the charging base
(using a needle or pencil is helpful).
Moving the switch to "S" side means the CL7200 will work in Stereo
mode. Moving the switch to "M" side means the CL7200 will work in Mono
mode
14 14