Tone Setting; Stereo/Mono Setting - Geemarc CL7500 OPTI Manual

SETTINGS

Tone Setting

The tone can be controlled by pressing the tone button on the
headphones� Press and hold this for 2 seconds, the button will
light up red� At this point, pushing headset '+' button will
increase the high tones� Pushing the '-' button will increase
the low tones� At minimum, maximum or middle point a beep
will be heard� If the buttons are not pressed, tone setting mode
will switch off automatically after 5 seconds.

Stereo/Mono Setting

Stereo or Mono mode can be controlled by moving
OFF/ON/Mono switch to the desired side� This switch is found on
the back of the charging base (using a needle
or pencil is helpful)�
Moving the switch to "ON" side means the CL7500 will work
-OPTI
in Stereo mode� Moving the switch to "Mono" side means the
CL7500 will work in Mono mode�
-OPTI
11