Troubleshooting - Geemarc CL7400 User Manual

TROUBLESHOOTING

No Sound
Ensure that the mains adapter is pushed fully into the power
outlet and that its cable is properly connected to the DC IN 5V
connector on the base.
Ensure that the headphones On/Off switch is switched to the
On Position and the button is lit Green.
The headphones battery charge level may be low. Replace the
headset back on it's cradle to recharge the batteries until the
green light is illuminated on the left hand headset.
Ensure that your DVD, TV set, Hi-Fi system or audio component
is switched on and set to a channel that broadcasts an audio
signal.
Use the headphones volume control to increase the sound level
(only when use as a wireless headphone).
The audio signal input level is too low. Increase the volume
from the audio source of Hi-Fi, CD, or TV, etc.
The connected audio/video equipment may not be in playback
mode. Start playback on by the equipment.
The headphones output level is set too low. Adjust the volume
to a suitable level.
19
TROUBLESHOOTING
Distortion
Restart the Pairing process.
The headphone's batteries charge level may be too low.
Recharge the batteries.
Ensure that the volume setting is correct.
The headphones may be too far away from the base. Move closer
to it.
The audio signal input level is too strong. decrease the volume
from the audio source of Hi-Fi, CD, or TV, etc.
Note:
In the event of the television not having the standard red and white audio
output RCA, or the audio jack, then it is most likely the TV will have an
optical audio output. By purchasing a Geemarc optical converter (our
reference CL7XX_OPT) this will allow the CL7400 to connect to the TV's
optical output successfully.
20