Safety Information - Geemarc CL7400 User Manual

SAFETY INFORMATION

General
To make the best use of this product and to use it safely, please read
these instructions thoroughly before use and keep them safe for future
reference.
This product can be very loud. Take care to prevent others from using this
product if they do not have the same level of hearing loss. Excessive
sound level from earphones and headphones can cause hearing loss.
Do not insert unattached plug heads in to mains power sockets. Plug
heads must be fitted to the power adaptor.
The unit is designed to operate from a 100-240VAC-50/60Hz supply.
(Classified as 'hazardous voltage' according to EN60950 standard).
The unit does not incorporate an integral power on/off switch. To
disconnect the power, either switch off supply at the mains power socket
or unplug the AC adaptor. When installing the unit, ensure that the mains
power socket is readily accessible.
Do not open the unit. Contact the helpline for all repairs.
Do not remove the earpads as they are very difficult to replace.
Please note: The unit may be subject to interference from appliances that
generate strong electrical or magnetic fields e.g. microwaves, mobile
phones, lighting transformers etc.
Cleaning
Clean the CL7400 with a soft cloth. Never use polishes or cleaning agents
- they could damage the finish or the electrics inside.
21
SAFETY INFORMATION
Environmental
Do not expose to direct sunlight or other heat sources.
Always ensure there is a free flow of air over the surfaces of the CL7400.
Do not place any part of your product in water and do not use it in damp or
humid conditions e.g. bathrooms.
Do not expose your product to fire or other hazardous conditions.
Battery Warnings
Do not attempt to dismantle
Do not dispose of in fire
Do not swallow
Keep away from children
Batteries are to be inserted with the correct polarity
Do not short-circuit the supply terminals
Exhausted batteries are to be removed from the product
Do NOT use another type of battery or non-rechargeable
batteries to replace the rechargeable batteries.
When the headphones are not in use or the batteries are charging, switch
OFF the headphones to avoid damaging the batteries.
The batteries must be fully charged when use for the first time. An initial 5
hours charge is required
Dispose of used batteries according to the instructions.
22