How To Stop An Alarm; Specifications - Oregon Scientific RMR132HG User Manual

HOW TO STOP AN ALARM

To stop an alarm, you can use either [24 hr
[AL ON/OFF].
To stop an alarm from ringing on the same day, press [24HR OFF
/ ((•))] or [AL ON/OFF ] once. Note that the alarm is still armed
and will go off at the set time the following day.
To deactivate the alarm function completely, press [AL ON/OFF ]
a second time.
PRECAUTIONS
This product is engineered to give you years of satisfactory
service if you handle it carefully. Here are a few precautions:
1. Do not immerse the unit in water.
2. Do not clean the unit with abrasive or corrosive materials. They
may scratch the plastic parts and corrode the electronic circuit.
3. Do not subject the unit to excessive force, shock, dust,
temperature or humidity, which may result in malfunction,
shorter electronic life span, damaged battery and distorted parts.
4. Do not tamper with the unit's internal components. Doing so
will invalidate the warranty on the unit and may cause
unnecessary damage. The unit contains no user-serviceable parts.
5. Only use fresh batteries as specified in the
mix new and old batteries as the old ones may leak.
6. Always read the user manual thoroughly before operating the
unit.
OFF / ((•))] or
Temperature Measurement
user manual. Do not
13
TIME ZONE AND OFFSET TABLE

SPECIFICATIONS

Main unit
Proposed operating range
Temperature resolution
Temperature compensation
Relative Humidity Operating range : 25% RH to 90% RH
: - 5.0°C to 50.0°C
( 23.0° F to 122.0°F)
: 0.1°C to ( 0.2°F)
: -10.0°C to 60.0°C
(14.0°F to 140.0°F)