Preamplifier And Procesors Specifications - McIntosh MHT100 Owner's Manual

Preamplifier and Processor Specifications
Frequency Response
STEREO Left and Right Loudspeakers:
+0 -0.5dB from 20Hz-20,000Hz
MUSIC 1-4 Left, Center, Right Loudspeakers:
+0 -0.5dB from 20Hz-20,000Hz
Large Surround Loudspeakers:
+0 -0.5dB from 20Hz-20,000Hz
PROLOGIC Left, Center, Right, Large Loudspeakers:
±0.5dB from 20Hz-20,000Hz
Large Surround Loudspeakers:
+1 -3dB from 20Hz-6.3kHz
Subwoofer
20Hz-140Hz
Dolby Digital, Left, Center, Right Large Loudspeakers:
DTS and ±0.5dB from 20Hz-20,000Hz
EXTERNAL Large Surround Loudspeakers:
INPUT ±0.5dB from 20Hz-20,000Hz
Subwoofer
20Hz-140Hz
Rated Output
2V for all channels
Input Impedance
22K ohms
Output Impedance
Less than 560 ohms for all channels
Maximum Output Voltage
8V
Total Harmonic Distortion
0.05% for all channels
Sensitivity
Analog Input: 100mV IHF
Dolby Level 200mV Input
External Input 200mV for 2.0V output
Signal To Noise Ratio
Greater than 90dB A weighted
Maximum Input Signal
Analog Input: 6Vrms
48
1and2
:
1and2
:
Preamplifier and Processor Specifications
Tone Controls
±12dB from the flat setting
1 If any of the Channels have the Loudspeaker Setting of
Small, the subwoofer has a electronic low pass filter with
a corner frequency of 80Hz and a 24dB per Octave
rolloff in all modes except external.
2
The Frequency Response of the Subwoofer Channel is
also detemined by the Crossover Setting.