Operate By Remote Control - McIntosh MHT100 Owner's Manual

How to Operate by Remote Control
The supplied remote control is capable of directly control-
ling the functions of contemporary McIntosh Source Com-
ponents connected to the MHT100. Earlier McIntosh
Source Components and other brand source components
can be controlled by the MHT100 with the addition of a
McIntosh Remote Control Translator (RCT) and/or op-
tional UR12 Touch Screen Remote Control.
Note: Your McIntosh Dealer can assist you with the
installation and operation of the Remote Control
Translator (RCT).
Mute
Press the MUTE Push-button to mute audio in the Zone
where the command is issued. The VCR OUTPUTS are not
affected by the MUTE function. The MHT100 Front Panel
Alphanumeric Display will indicate the word Mute. Press
MUTE a second time to unmute audio.
Mode
Press the MODE Push-button to select the Surround Mode
from Stereo to Cinema 2 plus External Mode for listening
to an Eight Channel Analog Audio Source.
Trim
Press the TRIM Push-button, followed by the LEVEL
Up or Down Push-button to select various sound ad-
justments and MHT100 Setup Settings.
Input Source Selection
Press any of the eight input Push-buttons to select a pro-
gram source, both audio and video.
CD/Tape Functions
Use these Push-buttons to operate a CD player, CD
changer or tape recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre-
sets or CD tracks/discs.
Disc and Track
Use the DISC and TRACK Push-buttons when a CD player
or changer is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel Up
Down Push-button to move from station to station. Press
and hold a Channel Up
over stations until the push-button is released. Press RE-
VIEW to start the automatic brief audition of each of the
or Down Push-button to skip
presets stored in the tuner memory. Press REVIEW a sec-
ond time to stop on a station preset and exit the Review
process.
Note: The above Tuner Function requires either the TM1
Tuner Module installed in the MHT100 or an external
McIntosh Tuner connected to the MHT100.
Volume
Press the Up or Down VOLUME Push-button to raise or
lower the listening volume level.
Note: The VCR OUPUTS are not affected by volume changes.
Acc On
Press ACC ON to turn the power ON to a McIntosh Disc
Player.
Acc Off
Press ACC OFF to turn the power OFF to a McIntosh Disc
Player.
E
Press E to perform various functions on a variety of McIn-
tosh Components. It will also pause the playing of a disc or
tape player.
Lighting
Press and release the LIGHTING Push-button to momen-
tarily illuminate the upper half of the remote control Push-
buttons.
Note: While the LIGHTING Push-button is being depressed,
the remote control will be unable to send a remote
command. When the LIGHTING Push-button is released
the Push-buttons will continue to stay illuminated for
approximately three seconds thus allowing you to send
the desired command. If any of the translucent Push-
buttons are depressed, they will continue to stay
illuminated for approximately three
seconds.
Optional Remote Control
The McIntosh UR12 Touch Screen Remote
Control combines a Multi-Page LCD
Touchscreen, joystick navigation and easy
to use command macros for operating all
the components in your system. See your
McIntosh Dealer for additional informa-
or
tion.
How to Operate by Remote Control
23