Video Components - McIntosh MHT100 Owner's Manual

How to Connect Video Components
Composite, S-Video and Component Video Signals can be
connected to and selected by the MHT100. The built-in On
Screen Operating Status and Setup Information is available
at the Composite and S-Video Monitor Outputs for Zone A.
Connect all of the available Source Video Outputs (Com-
ponent, S-Video and Composite) to the MHT100.
1. Connect video cables from the MHT100 DVD VIDEO
INPUTS to the McIntosh Video Outputs of the
MVP841 DVD Player.
2. Connect video cables from the MHT100 COMPO-
NENT VIDEO 2 INputs to the McIntosh Video Out-
puts of the MVP841 DVD Player.
Note: If a DVD is to be viewed in Zone B, make sure that
the Video Output Select Switch on the rear panel of
the MVP841 is set to the Composite/S-Video position.
3. Connect video cables from the MHT100 SAT VIDEO
INPUTS to the Video Outputs of a Satellite Receiver.
4. Connect video cables from the MHT100 COMPO-
NENT VIDEO 1 INputs to the Video Outputs of a Sat-
ellite Receiver.
DVD-Audio/SAC Player
Satellite Receiver
To AC
Outlet
McIntosh MVP841 DVD Player
How to Connect Video Components
5. Connect video cables from the MHT100 VCR1 IN-
PUTS to the VCR Video Outputs.
6. Connect video cables from the MHT100 VCR1 OUT-
PUTS to the VCR Video Inputs.
7. Connect video cables from the MHT100 CD1 INPUT
to the Video Outputs of the DVD-Audio/SAC Disk
Player.
8. Connect video cables from the MHT100 COMPO-
NENT Video, S-Video and Composite Video OUT-
PUTS to the Monitor/TV Component Video Inputs.
Note: If the Monitor/TV does not have Component Video
Inputs, then connect the MHT100 MON A S-Video or
Composite Output(s) instead.
9. Connect the MHT100 to a live AC Outlet.
Note: If the Zone B
is to be
connected,
proceed to the
next page and
DO NOT
connect the
MHT100 to a
live AC Outlet
at this time.
In Out
Monitor/TV
VCR
17