Subwoofer - McIntosh MHT100 Owner's Manual

16. Continue next to the SUBWOOFER SETTINGS.
If you do not wish to perform SUBWOOFER SET-
TINGS Adjustments at this time, then proceed to
the next step.
17. Select EXIT from the MAIN SYSTEM SETUP
Menu. If you are satisfied with the changes that
you may have made, select YES to save those
changes or NO not to save them. The MHT100
will then return to normal operation. Refer to fig-
ure 13 on page 25.
Using External Audio Source:
18. Using the Up
tons select number 2 (LEFT FRONT) from the
Speaker Level On-Screen Menu. Refer to figure
19.
19. Adjust the volume of the test signal by pressing
the LEVEL Up
Remote Control.
Note: The Left Front Loudspeaker volume level can serve
as a reference. If the level is increased or decreased, the
display will indicate numbers or minus numbers.
20. Using the Up
tons select number 3 (CENTER) from the Speaker
Level On-Screen Menu.
21. Adjust the volume of the test signal by pressing
the LEVEL Up
Remote Control.
22. Repeat the level adjusting procedure as often as
necessary until you are satisfied that the volume
levels are the same from all of the Loudspeakers,
then select EXIT on the menu. The MAIN SYS-
TEM SETUP Menu will reappear on the Monitor/
TV screen.
23. Continue next to the SUBWOOFER SETTINGS.
If you do not wish to perform SUBWOOFER SET-
TINGS Adjustments at this time, proceed to the
next step.
24. Select EXIT from the MAIN SYSTEM SETUP
Menu. If you are satisfied with the changes that
you may have made, select YES to save those
changes or NO not to save them. The MHT100
will then return to normal operation. Refer to fig-
ure 13 on page 25.
or Down directional push-but-
or Down Push-button on the
or Down directional push-but-
or Down Push-button on the
MENU: SPEAKER LEVEL
1. NOISE
2. LEFT FRONT
3. CENTER
2. RIGHT FRONT
3. RIGHT SURROUND
2. BACK SURROUND
3. LEFT SURROUND

2. SUBWOOFER

EXIT
Figure 20
Loudspeaker Levels
Location Default Setting
Left Front
Center
Right Front
Right Surround
Back Surround
Left Surround
Subwoofer
SETUP, con't
NO
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
New Setting
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
0.0dB
31