How To Operate The Mht100 - McIntosh MHT100 Owner's Manual

How to Operate the MHT100

The McIntosh MHT100 has been factory configured for
default operating settings that will allow immediate enjoy-
ment of superb video and high fidelity audio without the
need for further adjustments. If you wish to make changes
to the factory default settings refer to the SETUP Section
of this Owner's Manual.
Power On and Off
Press the POWER switch to ON and the Red LED above
the STANDBY/ON Push-button illuminates, to indicate the
MHT100 is in Standby Mode. Switch On the MHT100 by
pressing the STANDBY/ON Push-button. The title
MHT100 will appear on the Front Panel Alphanumeric
Display for approximately two seconds, with the Loud-
speakers muted. Refer to figures 28, 29 & 30.
Notes: For normal operation, turn the MHT100 On and Off
with the Standby/On Push-button. You may also
switch On the MHT100 by simply pressing the Power
Push-button on the Remote Control. If the A/V System
Controller is not going to be used for an extended
period of time, turn Off all AC Power with the Power
Switch. If the MHT100 is in the Standby Mode and
Zone B is active the Front Panel Alphanumeric
Display will indicate ZONE B ON. Refer to "How to
Operate Zone B" on page 47 for additional
information.
Input Selector
The INPUT Selector Switch selects the Listening/Viewing
Program Source for Zone A with the selected choice indi-
Figure 28
cated on the left side of the
Front Panel Alphanumeric Dis-
play. Refer to figure 29.
Note: The INPUT Selector
Switch also selects the
Record Output for
recording and the Zone B
Listening/Viewing
Program Source. Refer
to "How to Make a
Recording" on page 42
and "How to Operate
Zone B" on page 47 for
additional information.
Volume Control
The VOLUME Control allows
adjustment of the Listening
Level for all the Zone A Chan-
nels, with the indication of the
relative volume level displayed
on the right side of the Front
Panel Alphanumeric Display.
Refer to figure 29.
Notes: The VOLUME Control
can also adjust the Zone
B Listening/Viewing
Program Source, once
the Zone is active. Refer
to "How to Operate
Zone B" on page 47 for
additional information.
The maximum indicated
volume level will vary,
Figure 29
How to Operate the MHT100
Figure 30
39