Selecting Display Mode - Sony bvm-l230 Operation Manual

Operations

Selecting Display Mode

This monitor applies high-contrast to the picture and
reproduces accurate color by displaying the interlace
signal in progressive mode by the I/P conversion or the
PsF·progressive signal in progressive mode without the
I/P conversion.
You can select following mode according to the input
signal or the object to evaluate the picture.
• Black frame insertion display mode: A black frame is
inserted between the picture frames. It is convenient to
confirm the picture with multi-action scenes or roll
telop as the motion blur caused by the holding-type
display of the LCD is decreased.
• Interlace display mode: The picture is displayed in
interlace mode without I/P conversion processing. The
picture near the original quality of the input signal is
monitored.
Notes
• The luminance is reduced due to the principle of
operation in the black frame insertion mode and the
interlace display mode. However, on this monitor the
normal luminance is set by setting up the value of the
backlight luminance. For this reason, the black level is
set higher than the normal setting level and the range of
the contrast adjustment (backlight adjustment) is
different from the normal level, and the luminance may
be reduced according to the setting of the contrast.
• You cannot use both the black frame insertion display
mode and interlace display mode. When the interlace
display is set to on, the black frame insertion display is
not set to on.
• The black frame is not inserted in the following cases:
– When Interlace is set to On
– When the 24P or 24PsF input signal is displayed
– When Format of the Input Configuration menu is set
to DVI Computer
• The picture is not displayed in interlace mode in the
following cases:
– When Side by Side is set to On
– When Wipe is set to On
– When Butterfly is set to On
84
Selecting Display Mode
Chapter
– When Blending is set to On
– When Pixel Zoom is set to on
1
Set Native Scan (page 65) to On in the Display
Function menu for interlace display.
2
Set Interlace and Black Frame Insertion in the
Function Switch menu (page 65) of the Display
Function menu.
iiFunction Switch
Aperture: xxx
Mono: xxx
Blue Only: xxx
R Off: xxx
G Off: xxx
B Off: xxx
Chroma Up: xxx
Black Frame Insertion: xxx
Interlace: xxx
Setting Interlace and Black Frame
Insertion
Display mode
Progressive (factory setting)
Black frame insertion display
Interlace display
For the input signal to display in black insertion mode and
interlace mode, see "Picture·Frame Display" on
page 109.
4
v
2/4
V
Interlace Black Frame
Insertion
Off Off
Off On
On Off