Entry Deviation - IntelliSense SECURIT 900C Installation Manual

ENTRY DEVIATION MENU 96
Enter 96-(o). Enter 9 - 6 followed by the key corresponding to the Option
Number required from the table below:
Enter 0 Disabled (Default)
Enter 1 Enabled
PRINT EVENT LOG MENU 97
Enter 97-(o). Enter 9 - 7 followed by the key corresponding to the Option
Number required from the table below:
Enter 0 Disabled (Default)
Enter 1 Print log
time and date stamped
The full 250 Event
printer connected to the AUX supply and loudspeaker terminal via an adapter
(Part No. 2011-096 ). Connect to the panel as follows.
The data format is
• Baud Rate 1200
• Parity None
When a printer is connected, the print is started by entering 9-7-1 then
exiting Programming Mode by pressing # and *. The complete log will be
printed. The log will not print again until this operation is repeated.
Disconnect the printer, replace the control panel lid and reset the system.
VIEWING THE EVENT LOG AT THE KEYPAD
To view the 16 Event Log, Enter a valid User Code and press 0. The
most recently activated zone LED lights and the keypad will beep once.
The system will scroll through the history of the zone activations. If a zone
has been activated two or more times in succession the zone LED will
display and the keypad will beep for each activation. Softkey alarms are
indicated by all of the Zone LEDs displaying. The keypad will beep twice
in rapid succession at the end of the Log display. The time and date
stamp information will not be shown. The * key can be used to exit the
log at any time.
VIEWING THE EVENT LOG FROM DOWNLOADER
The IntelliSense Downloader software allows the 250 Event Log of the
panel to be viewed. See the downloader manual for more information.
Log can be printed in full by a serial
• Data Bits 8
• Stop Bits 2
19
ENTRY
DEVIATION
PRINT EVENT
LOG
VIEWING EVENT
LOG
VIEWING EVENT
LOG FROM
DOWNLOADER