Line Fault Inhibit Setting - IntelliSense SECURIT 900C Installation Manual

LINE FAULT
INHIBIT SETTING
BELL DELAY
BELL DELAY
PUSH TO SET
WHEN TO
COMMUNICATE
LINE FAULT
DOWNLOADER
OPTIONS
COUNT
LOCKOUT
ZONE ALARM
LINE FAULT INHIBIT SETTING MENU 73
Enter 73-(o). Enter 7 - 3 followed by the key corresponding to the
Option Number required from the table below:
Enter 0
Enter 1
BELL DELAY MENU 74
Enter 74-(o). Enter 7 - 4 followed by the key corresponding to the
Option Number required from the table below:
Enter 0
Enter 1
PUSH TO SET MENU 75
Enter 75-(o). Enter 7 - 5 followed by the key corresponding to the
Option Number required from the table below:
Enter 0
Enter 1
Enter 2
Enter 3
Enter 4
NOTE: Push to Set on full set is overridden if final contact/Door setting is
selected in Menu 41 (option 0)
WHEN TO COMMUNICATE MENU 76
Enter 76-(o). Enter 7 - 6 followed by the key corresponding to the Option
Number required from the table below:
Enter 1
Enter 2
Enter 3
Enter 4
LINE FAULT MENU 77
Enter 77-(o). Enter 7 - 7 followed by the key corresponding to the Option
Number required from the table below:
Enter 0
Enter 1
DOWNLOADER OPTIONS MENU 78
Enter 78-(o). Enter 7 - 8 followed by the key corresponding to the Option
Number required from the table below:
Enter 0
Enter 1
Enter 2
ZONE ALARM COUNT LOCKOUT MENU 79
Enter 79-(o). Enter 7 - 9 followed by the key corresponding to the Option
Number required from the table below:
Enter 0
Enter 1
No (Default)
Yes, inhibit setting with phone line fault
No (Default)
Yes, 10 minute bell/sounder delay on alarm
No timed or contact set (Default)
Yes, Full set only
Yes, Full & Part set
Yes, Full & Night set
Yes, All set modes
Full set only
Full & Part set
Full & Night set
All set modes (Default)
Disabled
Enabled (Default)
Full access allowed
No access when set (Default)
Prevent unsetting
Lockout after 2 alarms (Default)
Lockout after alarm
16