Bell Cut-Off Time; Part Set Exit Warning; Part Set Bells & Strobe; Night Set Bells & Strobe - IntelliSense SECURIT 900C Installation Manual

BELL CUT-OFF
TIME
PART SET EXIT
WARNING
PART SET
BELLS &
STROBE
NIGHT SET
BELLS &
STROBE
ALARM
TRIGGER
OUTPUT

QUICK SET

BELL CUT-OFF TIME MENU 43
Enter 43-(o). Enter 4 - 3 followed by the key corresponding to the Option
Number required from the table below:
Enter 1
Enter 2
Enter 3
Enter 4
Enter 5
Enter 6
Enter 7
Enter 8
Enter 9
PART SET EXIT WARNING SOUNDER MENU 44
Enter 44-(o). Enter 4 - 4 followed by the key corresponding to the Option
Number required from the table below:
Enter 0
Enter 1
Enter 2
Note. Night set will always be silent i.e. no exit and fault tones heard.
With option 2 selected, night set comfort and end of exit time fault tones
will be through both the keypad and internal speaker.
EXTERNAL BELLS & STROBE IN PART SET MENU 45
Enter 45-(o). Enter 4 - 5 followed by the key corresponding to the Option
Number required from the table below:
Enter 0
Enter 1
EXTERNAL BELLS & STROBE IN NIGHT SET MENU 46
Enter 46-(o). Enter 4 - 6 followed by the key corresponding to the Option
Number required from the table below:
Enter 0
Enter 1
ALARM TRIGGER OUTPUT MENU 47
Enter 47-(o). Enter 4 - 7 followed by the key corresponding to the Option
Number required from the table below:
Enter 0
Enter 1
Enter 2
QUICK SET MENU 48
Enter 48-(o). Enter 4 - 8 followed by the key corresponding to the Option
Number required from the table below:
Enter 0
Enter 1
When enabled, users set the system by pressing the # key and 1 (to Full
Set), 2 (to Part Set), or 3 (to Night Set). A valid user code is still required
to unset the system.
1 Minute
2 Minutes
3 Minutes
4 Minutes
5 Minutes
10 Minutes
15 Minutes
20 Minutes (Default)
30 Minutes
Fault & comfort tones only (Default)
Keypad buzzer only
Keypad buzzer and sounder
Off
On (Default)
Off
On (Default)
0 V Detector reset
Set Latch positive
Alarm (Default)
Off (Default)
On
12