Figure 6-4. Keyboard Flex Connection; Figure 6-5. Microphone And Speaker Connections - Motorola Commercial Series Basic Service Manual

Hide thumbs Also See for Commercial Series:
Table of Contents

Advertisement

Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
CAUTION: Marring the front cover O-ring sealing area will prevent the radio from sealing properly.
If the O-ring is damaged, replace it with a new one.
!
!
W A R N I N G
6. Pull the chassis assembly out of the front cover only until the volume and channel selectors shaft
just clear the top of the case.
7. Rotate the bottom of the chassis up about 20° to disconnect the keyboard flex cable connector.
Push down 2 end tabs to release flex connector at the bottom of the chassis.
8. Rotate the chassis counterclockwise out of the housing and position next to the housing. Take
care not to damage the speaker and microphone wires that are still connected to the chassis
(Figure
6-5).
9. Unplug the speaker wire assembly from the 2-pin connector on the chassis.
10. Unplug the microphone wire assembly from the socket on the chassis.
11. Move the chassis away from the housing and place on a clean work surface
68009328001-A
(Figure
6-4).

Figure 6-4. Keyboard Flex Connection

Microphone
Connector

Figure 6-5. Microphone and Speaker Connections

Radio Chassis
Flex Connector
Speaker Connector
6-5
December, 2009

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents