Speaker Output - ELECTROCOMPANIET AW600 NEMO Owner's Manual

USA GB
How to connect your system
Please read this page carefully and follow diagram 1.
Inputs
Balanced operation only.
Outputs

SPEAKER OUTPUT:

Never short the positive or the negative output to ground or chassis.
Switch the amplifier off when connecting the speakers.
How to power up your system
You should always power up your system in the following way:
Signal sources (CD player, tuner, etc.) first, then preamplifier.
Allow a 30 seconds warm-up before you turn on the AW 600.
When switching off your system
Start with the AW600, then the preamplifier and at last the signal sources.
The main switch is located in the center of the lower part of the rear.
If the AW 600 has been switched off, allow two hours of warm-up for optimal sonic
performance.
When the AW 600 is not to be used for a long period of time, use the main switch to turn the
unit off.
Then disconnect the AC main cord for maximum safety.
2