Dry Ironing; Self-Cleaning - Singer SG2535 Instruction Manual

ENGLISH
Selecting the steam.
The quantity of steam is regulated by the steam selector (3).
- Move the steam selector to a position between minimum and maximum depending on the
quantity of steam required and the temperature selected [Fig. 1].
Warning: the iron gives off steam continuously only if you hold the iron horizontally. You can
stop the continuous steam by placing the iron in a vertical position or by moving the steam se-
lector to "0". As indicated on the thermostat knob (10) and in the initial table, you can only use
steam at the highest temperatures. If the selected temperature is too low, water may drip onto
the plate.
Selecting Shot-steam and steam when ironing vertically.
Press the shot-steam button (5) to generate a powerful burst of steam that can penetrate the
fabrics and smooth the most diffi cult and tough creases. Wait for a few seconds before pressing
again [Fig. 4].
By pressing the shot-steam button at intervals you can also iron vertically (curtains, hung gar-
ments, etc.) [Fig. 5].
Warning: the shot-steam function can only be used at high temperatures. Stop the emission
when the plate temperature control light (8) comes on and start ironing again only after the light
has gone off.

DRY IRONING

To iron without steam, follow the instructions in section "steam ironing", leaving the steam selec-
tor (3) on position "0".
Spray Function
Make sure that there is water in the reservoir. Press the spray button (4) slowly (for a dense
spray) or quickly (for a vaporized spray) [Fig. 6].
Warning: for delicate fabrics, we recommend moistening the fabric beforehand using the spray
function (4), or putting a damp cloth between the iron and the fabric. To avoid staining, do not
use the spray on silk or synthetic fabrics.
CLEANING
Please note: before cleaning the iron in any way, make sure that the appliance plug is not con-
nected to the socket and the iron is completely cool.
Any deposits, starch residue or size left on the plate can be removed using a damp cloth or an
unabrasive liquid detergent. Never use abrasive, vinegar or other chemical agents to clean the
iron.
Avoid scratching the plate with steel wool or metallic objects.
The plastic parts can be cleaned with a damp cloth then wiped over with a dry cloth.

SELF-CLEANING

The self-cleaning feature cleans inside the plate, removing impurities. We recommend using it
every 10-15 days. Directions:
-Fill the reservoir up to the maximum level indicated and set the steam selector (3) to "0"
7