Main Fuse (Slow-Blow Fuse) (Ag); Main Fuse (Slow-Blow Fuse) (Ag); Aligning Wheel And Checking Wheel Nut (Ah); Aligning Wheel And Checking Wheel Nut (Ah) - Cushman 646442 Owner's Manual

7
hauler 4x4 Diesel
-0

MAIN fUsE (sloW-BloW fUsE) (AG)

(1) slow-blow fuse
if the start motor and all electrical de-
vices do not operate at all when turn-
ing the key the switch to the "start"
position, the first thing to inspect is
the main fuse.
1. remove the engine inspection
shield.
2. check if the yellow slow blow fuse
installed to the positive start motor
cable is blown.
3. remove the tape and replace the
fuse with a new one if necessary.
4. Wrap the fuse with insulation tape
after replacement. Make sure that
the inspection shield is visible.
5. if this fuse is repeatedly blown,
contact your Dealer.
UUVo758A
AlIGNING WhEEl AND
ChECkING WhEEl NUT (Ah)
1. park the vehicle on level ground
and apply the parking brake firmly.
(1) Wheel nut
2. unscrew the nuts on the wheel to
be replaced for only 1 turn.
3. lift the vehicle with a hydraulic
jack and then support the vehicle
with the safety stand. then, lower
the hydraulic jack so that the vehi-
cle chassis sits on the stand.
4. unscrew the wheel nuts complete-
ly to remove the wheel.
UUVo746A