Vehicle Storage; Daily Storage; Long-Term Storage - Cushman 646442 Owner's Manual

Hauler 4x4 diesel 2 passenger
Table of Contents

Advertisement

8
haUler 4X4 diesel
-

vEhIcLE STORAGE

DAILy STORAGE

1. Keep the vehicle clean when it is
stored. make sure to wash it after
work.
2. store it indoors if possible. if it
should be kept outside, cover it.
WARNING
When operating the vehicle in
an enclosed area, ventilate the
area to release exhaust gas to
the outside. The exhaust gas
is colorless and not visible,
but is harmful.
In an area that exhaust gas can
come in contact with a flame
or spark, do not store the vehi-
cle with fuel in its fuel tank.
cool down the engine suffi-
ciently before covering the ve-
hicle with a protective cover.
3. remove the battery from the vehi-
cle in winter and store it indoors.
4. add anti-freeze to the vehicle in
winter season in order to prevent
the radiator from freezing.
5. remove the ignition key and store
it separately.

LONG-TERm STORAGE

follow the instructions below if the
vehicle is not to be used for a long
period of time. this is to operate the
vehicle again with minimum prepara-
tion after long-term storage.
ImPORTANT
If the vehicle is not used for an
extended period of time, fol-
low the instructions below to
prevent corrosion and perfor-
mance deterioration of the ve-
hicle while it is stored.
1. check the bolts and nuts for loose-
ness, and tighten if necessary.
2. apply grease to areas where bare
metal can rust.
3. repair worn or damaged parts.
replace parts as necessary.
4. Inflate the tires to a pressure a lit-
tle higher than usual.
5. remove the battery from the ve-
hicle. store the battery according
to the applicable storage instruc-
tions.
6. Keep the vehicle in a dry place
where the vehicle is sheltered
from rain. cover the vehicle.
7. the vehicle should be stored in
an enclosed area to avoid direct
sunlight or heat. make sure the
tires are not exposed to sunlight
and heat directly.
8. Keep the vehicle, including the
engine components, clean.
9. Apply grease to every grease fit-
ting as needed.
10. apply grease to the exposed cyl-
inder rod (if equipped with the
dumping kit).
11. check the coolant condition. if
necessary, drain and flush it, and
then refill with anti-freeze and
water. We recommends a 50/50
mix.
12. set the shift lever to the neutral
position.
13. attach a tag onto the vehicle to
inform the storage condition of
the vehicle.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents