Replacing The System Board; Procedure - Dell Alienware 15 Service Manual

Replacing the system board

WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
After working inside your computer, follow the instructions
in After working inside your
practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
NOTE: Your computer's Service Tag is stored in the system board. You
must enter the Service Tag in the BIOS setup program after you replace
the system board.
NOTE: Replacing the system board removes any changes you have made
to the BIOS using the BIOS setup program. You must make the desired
changes again after you replace the system board.

Procedure

1 Follow the procedure from step 1 to step 2 in "Replacing the
battery".
2 Follow the procedure from step 1 to step 2 in "Replacing the
assembly".
3 Turn the system board over.
4
Slide the ports on the system board into the slots on the computer base
and align the screw holes on the system board with the screw holes on the
computer base.
CAUTION: Make sure that no cables are under the
system board.
5
Replace the screws that secure the system board to the computer base.
6 Slide the I/O-board cable into the system board and press down on the
latch to secure the cable.
7 Connect the speaker cable to the system board.
8
Connect the front AlienFX LED cable to the system board and secure it with
the tape.
9
Turn the computer over.
10 Connect the fan cables, power-adapter port cable, and hard-drive cable to
the system board.
118
Before working inside your
computer. For more safety best
computer.
coin-cell
heat-sink