Advertisement
Page 8
CLEAR ALL REMOTE CONTROL CODES
Follow this procedure to clear all remote controls programmed to operate the system. Please note, if you
have remote controls to program into the system and you want to first clear all existing remote controls
from the system, follow the reprogram procedure as shown on pages 4 and 5.
1. Before you begin:
Open the driver s door and remo ve the key
from the ignition switch.
2. Start the programming procedure. (Complete these steps within 40 seconds.)
a. Insert the key into,
and remove it from
the ignition switch 2
times.
e. Insert the key into,
the ignition switch
and leave it in.
i.
The tail and marker lights flash 5 times,
the buzzer chirps 5 times and the doors
lock and unlock 5 times.*
* If the system does not activate the lights, buzzer and door locks 5 times, start over.
TOYOTA TVIP SYSTEM PROGRAMMING−RS3200
b. Close, then open
the driver s door 2
times.
f.
Close the driver s
door.
c. Insert the key into,
and remove it from
the ignition switch 1
time.
g. Turn the key from
LOCK to ON 5
times (ending at
LOCK).
3. Complete the code clearing
procedure.
a. Open the driver s door
d. Close, then open
the driver s door 2
times.
h. Remove the key
from the ignition
switch.
Hide quick links:
Advertisement
