Advertisement
Page 4
REPROGRAM EXISTING REMOTE CONTROLS
Follow this procedure to clear all existing remote control codes and reprogram existing remote controls to
a system. When existing remote controls are reprogrammed, they will work in the default operation mode
(press the UNLOCK button twice to unlock all doors and no AUX button function on 4 button remote
controls); to change the operation mode, you must perform the separate REMOTE CONTROL
FUNCTION SELECT procedure as shown on pages 6 and 7.
1. Before you begin:
Open the driver s door and remo ve the key
from the ignition switch.
2. Start the programming procedure. (Complete these steps within 40 seconds.)
a. Insert the key into,
and remove it from
the ignition switch 2
times.
e. Insert the key into,
the ignition switch
and leave it in.
i.
The tail and marker lights flash 2 times,
the buzzer chirps 2 times and the doors
lock and unlock 2 times.*
*If the system does not activate the lights, buzzer and door locks 2 times, start over.
TOYOTA TVIP SYSTEM PROGRAMMING−RS3200
b. Close, then open
the driver s door 2
times.
f.
Close the driver s
door.
c. Insert the key into,
and remove it from
the ignition switch 1
time.
g. Turn the key from
LOCK to ON 2
times (ending at
LOCK).
d. Close, then open
the driver s door 2
times.
h. Remove the key
from the ignition
switch.
Hide quick links:
Advertisement
