Advertisement
Page 10
IGNITION− CONTROLLED AUTOMATIC DOOR LOCK/ UNLOCK
When all doors are closed, the RS3200 is factory set to automatically lock the vehicle s door when the
ignition key is turned to ON or START, and unlock them (open or not) when the key is turned back to
ACC or LOCK. Follow the procedure below to change this feature s operation mode.
1. Before you begin:
Open the driver s door and remo ve the key
from the ignition switch.
2. Start the programming procedure. (Complete these steps within 30 seconds.)
a. Insert the key into the
ignition switch and turn
it from LOCK to ON 5
times (ending at ON).
Note: If the system does not activate the lights and buzzer, start over.
3. Select the operating mode and complete the programming steps.
a. Close the door: Ignition
controlled door locks on.
Close, then open and
close the door: Ignition
controlled door locks off.
TOYOTA TVIP SYSTEM PROGRAMMING−RS3200
b. The tail and marker
lights flash 1 time, and
the buzzer chirps 1
time.
b. Turn the ignition
key back to lock.
c. The status monitor sLED
(or the engine immobilizer
system s L ED) turns on
for 30 seconds.
b. The tail and marker lights flash 1
time, and the buzzer chirps 1 time
if the system was set for IG door
lock control ON, twice for IG door
lock control OFF. If this does not
happen, start over: otherwise,
programming is now complete.
Hide quick links:
Advertisement
