Vehicle security system corolla (e12-a + e12-d) (71 pages)
Summary of Contents for Toyota vss3
Page 1
Vehicle Security System VSS3 - Alarm system remote System Setting Guide - English...
Page 2
PIN Code, with a maximum .5 second delay between one press and the next. If the LED is already on when the button is pressed, it will go out. Wait for the LED to flash indicating that the next digit can be entered. Repeat the process for all four digits. VSS3...
The blinker will flash x every 2 sec, and the LED will remain ON as confirmation that you have entered the programming mode. Note: – If the LED does not light ON, withdraw the key from the ignition and repeat the procedure. VSS3...
Page 4
Refer to the following table for the programming mode selection steps overview. – Turn the key to IG Off and IG ON again Note: – The Blinkers will flash x every 0 sec, and the LED will flash x every 3 sec to confirm you have reached the Mode . VSS3...
Page 5
x fast every 3 sec: function is disabled. flashing x slow every 3 sec: function is enabled. If you want to change the setting, press and hold the LED push button once. Note: press 6x the LED push button to go to Mode 3.. VSS3...
The blinker will flash 5x to confirm. Notes: – You can exit the programming mode at any time by closing the bonnet. – for the Aygo, you can exit the programming mode at any time by closing the driver’s door. VSS3...
Page 8
Once entering the learning mode, all existing system remote are deleted. You have to reprogram all of them individually. – The alarm system accepts up to 4 remote controls. Remark: – In case you have lost a remote control, reprogram your remaining remote(s). This will deactive all the other remotes. VSS3...
beep sound if 30 seconds, press buzzer enabled the lock button once again. Summary: Press the alarm remote twice within 30 seconds. Note: – The interior sensor is deactivated once only. Next time the interior sensor will be activated again. VSS3...
30 sec., press the buzzer enabled. lock button again twice. Summary: press the alarm remote 3 times within 30 sec. Note: – The sensor is deactivated for use only. Next time you arm the alarm, the sensor will be activated again. VSS3...
The hazards and LED will give long flash and a long beep beep will sound for confirmation. To exit: . Turn IG ON. 2. Long push on the remote unlock button, or on the LED push button. Note: During garage mode, the LED will flash at each ignition ON. VSS3...