Table of Contents
Advertisement
Fu ll Erase HDD
This function is used to full erase all data on the HDD. Please backup any important data before
using this function.
Press ENT to enter the following scr een. Use the Up and Down buttons to select the HDD to
erase.
Press ENT again and the LCD will prompt you to confirm the er ase operation.
H/W Diagnostic
Press ENT to enter the following screen. This function is used to check that the system is
operating normally.
Press ENT again to enter the following screen. The LCD will cycle through the test categories as
they are performed. The LCD display is tested first, the control panel is tested next (requires
manual operation), then followed by the system's internal diagnostics, hardware connection test
then the RAM and SD Flash test. All test results are shown on the LCD. This is a simple way to
verify that the system is operating normally.
Press ENT and the system will begin the tests as shown below.
LCD Test Start
Tes t IDE 0/1
OK
Once the system diagnostics have been completed the "Test finished" message will appear on the
LCD.
www.addonics.com
11- 05.Adv Setup
Full Erase HDD
Quick Erase HDD
ALL/Target CH:*
All data w ill be
lost,Erase? No
11-06.Adv Setup
H/W Diagnostic
Button Test ?
FlashTest: OK
Technical Support (M-F 8:30am - 6:00pm PST)
SDRAM Test:
8192 Kbytes OK
Test Finished
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Advertisement
Table of Contents
