Table of Contents
Advertisement
Device Info
This option is used to display the details of all hard disks connected to the copy controller.
Press ENT and the LCD will display each hard disk' information in order as shown below.
System Info
This option displays system information .
Fast Copy
This option displays Fast Copy. Fast Copy only copies data on the source drive
to the target drives. Currently only supports FAT, FAT32, NTFS, HFS, Ext2 and
Ext3 partitions.
Press ENT and the LCD will display the following info. Use the Up and Down arrow keys to choose
whe
Ext2 and Ext3 partitions.)
Auto Start Drive
This opti o n is used to display to copy automatically once you insert HDD on target port.
Press ENT to enter the foll
choose 1-11.
Auto Start Timer
This option is used to set the period of time when the duplicator starts copying
automatically once you insert HDD on target port. Default is set at OFF, use the
arrows to choose time.
Press ENT to enter the following figure. The default is 0. Use t he Up and Down a rrow keys to
choose 5 Sec- 50 Sec.
www.addonics.com
10-06. Setup
Device Info
0 Source CH: 0
Hitachi 232.9GB
10-07. Setup
System Info
10-08. Setup
Fast Copy
unction currently on
ff
Fast Copy
On
10-09. Setup
Auto Start Drive
fi
defau
Auto Start Drive
10-10. Setup
Auto Start Timer
Auto Start Timer
Technical Support (M-F 8:30am - 6:00pm PST)
, FAT32, NTFS, HF S,
ff
he Up and Down arrow keys to
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Advertisement
Table of Contents
