Programmable Trigger Output Connections; System Trigger Out Connections - Elan s86a Installation Manual

S86A
E L A N H O M E S Y S T E M S
INSTALLATION MANUAL

Programmable Trigger Output Connections

There are 6 zone-specific Trigger outputs on the S86A Controller. Use these when zone-specific functions are
desired; for example, use the PROGRAMMABLE TRIGGER OUTPUTS to mute/un-mute specific channels on an
A12 or D12 amplifier. Use 3.5mm mono interconnect cables to connect the S86A Controller's PROGRAMMABLE
TRIGGER OUTPUTS to the device that needs to be turned on.
Figure 3-31: Programmable Trigger Output Connections

SYSTEM TRIGGER OUT Connections

Use the SYSTEM TRIGGER OUT to connect devices that need to be turned on when any zone of the system is
turned on. The SYSTEM TRIGGER OUT sends a signal when any zone of the S86A controller is turned on. Using
VIA!TOOLS or ELANTOOLS Setup Software, the SYSTEM TRIGGER OUT can be programmed to become active
based on IR or Serial commands. Use 3.5mm mono interconnect cables to connect the S86A Controller's SYSTEM
TRIGGER OUT to the device that needs to be turned on.
Figure 3-32: System Trigger Out
© ELAN Home Systems 2009 • All rights reserved. Page 43