C" Punchdown Locations; Z•Pad Connections - Elan s86a Installation Manual

S86A
INSTALLATION MANUAL

"C" Punchdown Locations

Figure 3-9 shows connectivity to the "C" location and utilizing internal 12VDC power from the S86A Multi-Room
Controller.
Z•Pad Connections
"C" Punchdown Locations
It is possible to use ELAN Z•Pad keypads as zone controllers in an S86A-based system. These keypads will con-
trol IR sources and S86A Controller function, but they WILL NOT receive RS- 485 status feedback. This means that
source selection status, shared source status, etc. will not be available to these keypads. Source selection and con-
trol are enabled and will function correctly.
Note: ELAN Z PAD keypads will NOT receive status feedback when
connected to the S86A.
Page 30
Figure 3-9: Olé Touchpad "C" Internal 12VDC Connections
Figure 3-10. Z•Pad Connections
E L A N H O M E S Y S T E M S
S86A
S86A
S86A
© ELAN Home Systems 2009 • All rights reserved.