Table of Contents
Advertisement
4.7.2 Electrical Wiring
(1) For solid core wiring (Fig.27)
1) Cut the wire end with a wire cutter or wire-cutting pliers, then strip the insulation about 25
mm (15/16") .
2) Using a screwdriver, remove the terminal screw(s) on the terminal board.
3) Using pliers, bend the solid wire to form a loop suitable for the terminal screw.
4) Shape the loop wire properly, place it on the terminal board and tighten securely with the
terminal screw using a screwdriver.
(2) For strand wiring (Fig.27)
1) Cut the wire end with a wire cutter or wire-cutting pliers, then strip the insulation about 10
mm (3/8") .
2) Using a screwdriver, remove the terminal screw (s) on the terminal board.
3) Using a round terminal fastener or pliers, securely clamp a round terminal to each stripped
wire end.
4) Position the round terminal wire, and replace and tighten the terminal screw with a
screwdriver. (Fig.28)
Fig.28
Floor Ceiling Air-Conditioning Unit
Fig.27
19
Fig.29
Advertisement
Table of Contents
