Chapter 11 Appendices; Appendix 1: Audio; Appendix 2: Gpi Out - Datavideo SE-1200MU Instruction Manual

Chapter 11 Appendices

Appendix 1: Audio

The SE-1200 MU can only accept external
audio using the analogue XLR inputs on the
rear panel. Ideally a master audio mixer
should be used alongside the SE-1200 MU. A
Datavideo AM-100 audio mixer or AD-200
audio delay unit could be considered.
Changing the Audio Mode option from
Analog to OFF will mute the incoming XLR
audio from the external master audio mixer.
The Audio sub-options for SDI and HDMI
allow the user to individually turn ON/OFF
the audio at the SDI 1, SDI 2 and HDMI 1 outputs.
Audio Level relates to the preferred audio standard for the user. A choice of SMPTE or EBU is given.
Note: Audio is not supplied with the IP streamed multi view. Local SDI and HDMI outputs can provide the
audio.

Appendix 2: GPI Out

Outputs Menu
This allows the user to perform GPI
configuration.
After turning On the GPI Enable, select the GPI
Mode, which is either set as Level or Pulse. The
GPI signal Width can also be configured by
setting a value (1~9).
The GPI out can then be assigned to one of the
inputs 1~4 under Source. When the selected
channel/source is taken to the Program output
the GPI signal is triggered. A GPI Delay can be
set between 0 and 99.
This feature could be used to trigger playback from units such as the Datavideo NVP-20 or HRS-30 or HDR-
60/70.
55