Ac Mains Supply Cable - Montarbo Spot 2500T User Manual

PROFESSIONAL LOUDSPEAKER SYSTEM PROFESSIONAL LOUDSPEAKER SYSTEM

3.2 - AC MAINS SUPPLY CABLE

Use the cable supplied with the system. If another cable is needed, always
use a cable with specifications suitable to the value of the current involved,
considering the current drain of the system and, just in case, the current
drain of the devices powered by the AC LOOP OUT socket.
CAUTION
The AC LINE IN socket (1 page 6) is rated for a 20A maximum current.
This means that the maximum current that may be sourced from the
AC LOOP OUT socket (2) is 13.6A (20A: max current rating of POWERCON
input socket - 1 - minus 6.3A = maximum current drained by SPOT2500T
system).
The maximum current drain of the sum of the devices powered by the
cable connected to the AC LINE IN socket (that means the current drain
of the SPOT2500T system plus the maximum current drain of all the other
devices powered by the AC LOOP OUT socket) must be lower than 20A.
The AC socket that powers connector (1), the mating plug and the cable
must be suitable for this current value.
When in doubt, always recruit the assistance of a qualified technician.
We suggest the use of a 3-conductor cable, with a 3 x 1,0 mm
copper section (gauge), suitable for the intended application and
environment and complying with all the relevant safety regulations.
The cable and the plug must be marked with the applicable,
country-specific safety approvals, and the plug must be certified for the
actual current value.
Refer to the following paragraph for details about wiring of the
POWERCON ®
connector.
user's manual
®
2 minimum
13
ENGLISH